Welcome to Vansco Inc.
Serving our industry with quality built machines for over 30 years.

Vansco Model M-700
Mechanical Hot Stamping Press

· Capacity 7 tons (pressure).
· Heating head C.I. 4.0 x 5.0
· Approximate weight 1100 lbs.
· Variable speed motor 3/4 HP DC.
· Ground steel frame with weldments.
· Electrical requirements 240 VAC 3 phase.
· Mechanical leaf advance 0-3.625 pulling.
· Mechanically driven gears provide solid toggle motion.
· Speed from 35-80 imprints per minute (base on set-up).
· Pneumatic requirements 80 PSI for clutch knife/bolt.
· Auto rewind, adjustable rollers, quick release take-up shaft
· Also available: other head sizes, compression fixture, leaf width special set-ups.

Operating Features

· Adjustable table assembly with heavy support block and screw.
· Dovetail position is front to back or side to side.
· Start/stop with "E stop"
· Solid state heat controller with soft touch set-points, bright led display, run mode, disconnect.
· Clear rigid guarding, hinged three sides with electrical interlock.

Vansco Inc., reserves the rights to change specifications , designs, materials, discontinue certain models, and any other
components without notice or obligation. By doing so, we continue to provide quality in practical production ready equipment, along with service and price.

Home | Service | Roll-Leaf Cutting Machines | Hot Stamping Equipment
Roll-On Equipment | Mechanical Presses | Supplies and Parts | Contact
Vansco Inc. © 2008 All rights reserved. VanscoEquipment.com
Site Powered By Serious Designs